I attached the procedure and location of the mode door for you
Removal:
Warning: on vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in an accidental airbag deployment and possible personal injury.
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Remove the left and right underpanel silencer/ducts.
Fig. 16 Blend Door Actuator Location
imageZoom/Print
3. Remove the two screws from the actuator which are accessible from the right side of the center stack.
4. Remove one screw from actuator on the left side.
5. Pull the actuator straight down from shaft and disconnect the electrical connection. Upon removal, note the shaft position of the actuator, because the shaft on this motor is keyed. When installing a new actuator, its shaft must be positioned in the same location.
Installation:
1. Connect the wire harness connector to the blend door actuator.
2. Install the blend door actuator on the HVAC housing, making sure its keyed shaft is positioned properly.
3. Install the three fastener screws and tighten to 2.2 Nm (20 in. Lbs.).
4. Install the left and right underpanel silencer/ducts.
5. Connect the negative battery cable remote terminal to the remote battery post.
 |
| blend door actuator location |
No comments:
Post a Comment