2003 CHEVY S-10 BODY PARTS

2003 CHEVY S-10 BODY PARTS


2003 Chevy S-10 4 cyl Two Wheel Drive Manual 59800 miles


I would like to now what other TRUCK PARTS would fit my truck? Left front fender, front bumper, spacer between bumper and grille, grille, plastic air flow that fits on bottom of bumper

Answer:
These will fit, GMC Sonoma, Chevy Blazer, GMC Jimmy. Make sure you get 2 door parts only. They all have the same front ends.
If you call a local junkyard they have the crossover book, if any will fit, they know it!


Comments

Post a Comment

Popular posts from this blog

1995 Z24 chevy cavalier wont even turn over

1995 Z24 chevy cavalier wont even turn over I have a 1995 Z24 chevy cavalier, I have power to my lights, stereo, and everything else. I turn my key to start the engine, and it clicks twice, and it hums. also, without the key even in the ignition, my alternator is making a quiet buzzing noise.  Obviously the alternator is running to earth inside ,could be a rectifier diode .change alternator and recharge battery not enough power to throw solenoid in on the starter motor because the alternator has drained it .leave car a bit longer and nothing will work .disconnect battery now to stop it draining further and to avoid a possible fire risk. Car Repair World Troubleshoot All types of Car Problem with proper Solutions http://carrepairworld.blogspot.com/2015/03/how-to-repair-car-problem.html   Know Exactly How Each And Every Part In Your Car Works http://carrepairworld.blogspot.com/2015/04/how-does-it-work.html   Troubleshoot Car OBD Codes. Know...
Read more

Hood Opening Instructions

Image
How To Open Car Hood Helpful Information Opening a vehicles hood is a relatively simple task that can be done in a few minutes with no tools required. The hood release consists of two latch stages, primary and secondary. The secondary latch is designed as a safety device, if the hood is accidentally released while driving, it will not open completely and cause a vision obstruction. Make sure the hood is properly secured by using the prop rod or shock before removing your grip. A prop rod will need to be installed into a designated position to hold the hood up properly. If a hood is slightly damaged or has a sticky latch it can cause the hood not to "pop" open, in this case use a helper to pull up on, or push down on, or even small rap with a hand on the hood near the latch to assist the primary latch to release. (Note: When performing this action use caution to not dent the hood.) After hood has been opened, occasionally the latch will fall closed not allowing the striker ...
Read more

Door Lock Replacement

Image
The electric door locks inside of your car doors consist of a control switch, the locking door latch and/or an electric control solenoid. When the control switch is energized an electrical impulse forces the control solenoid to push or pull the locking mechanism depending on the command selected. (Lock and unlock). Anytime you have problems with an electric door lock check the fuses or thermo fuse the powers the system. Step 1 - Identity Door Switches and Controls Door Panel Components The average vehicle door has basic controls for the different functions the door performs. Interior light and safety reflector helps illuminate the interior of the vehicle. When the door is open the light and the reflector alert people from a distance your door is open. The electric window switch controls the electrical power to the window motor. The motor turns a series of gears and/or cables to power the window up and down. The electric door switch controls electrical power to the lock sol...
Read more